Welcome to Receiving Inspection for the Maxine Regular!
start
 
Who is performing this inspection? *




 
Do the two halves of cast knuckles on both ends seat together properly? *

Do the cast spherical half-balls engage fully with the mating holes?
     
 
Have the internal corners of the cast knuckles been ground down to provide a smooth pathway for the wires?

     
 
Do any of the cast half-spherical holes break out to the outer surface? *

     
 
Is the check ring that mates to the shade been replaced with a spacer? *

     
 
Do the solder seams on the joints meet the UECo standards? *

Especially on polished nickel finish.
     
 
Do you see any oxidation in the seams of the shade due to moisture left in the bag? *

Especially on polished nickel finish.
     
 
Do you see any scratches on the round knuckle surface at each articulation point?

Especially on polished nickel finish.
     
 
Is the pipe thread on the shade side within 5/8" +/- 1/16"?

     
 
Is the pipe thread on the canopy side within 5/8" +/- 1/16"?

     
 
Is the threaded stud on the knuckle of the shade side within 5/8" +/- 1/16"?

     
 
Is the threaded stud on the canopy of the shade side within 5/8" +/- 1/16"?

     
 
Congratulations on completing the Maxine Receiving Inspection!

Thank you, {{answer_8622691}}!
again
Thank you, {{answer_8622691}}!
again